Re: [PVE-User] OS Error after upgrade to 7.1

[Ralf Storm <ralf.storm@konzept-is.de>]

Hello Stefan,

I had the old Firmware (from2015?) 000..26 - the ri version not the it 
version - this did not work on the 5.13 Kernel - stuck at boot and 
server rebooting after a while

the newest version i found was from 2016 000..27 , which works, it is 
hard to find any firmwares as the vendor does not supply it anymore, 
there are descriptions howto update and links to the firmware, but the 
links are dead...

Has to be updated in efi shell from usb drive


hope that helps,

best regards

Ralf


Hi Ralf

Would you mind to share the old and new firmware versions of your controller and your kernel version?

It might help other PVE users to avoid the problem you have run into.

Thank you

Stefan

> On Nov 24, 2021, at 11:24, Ralf Storm<ralf.storm@konzept-is.de>  wrote:
>
> Hello,
>
>
> Proxmox is starting again after upgrading the firmware of the 9211-8i controllers...
>
> And yes it did boot with the old Kernel, so the Firmware of the controllers was incompatible with thie new Kernel.
>
>
> Ralf Storm
>
>
> Systemadministrator
>
>
>
> Konzept Informationssysteme GmbH
>
> Am 23.11.2021 um 14:37 schrieb Uwe Sauter:
>> Am 23.11.21 um 14:34 schrieb Ralf Storm:
>>> Hello,
>>>
>>>
>>> yes - I have a problem, as mentioned in my first mail, the system is stuck at boot with this message
>>> and then after a few minutes reboots...
>> Can you reboot with the previous kernel and check the firmware of the controller?
>>
>> dmesg | grep mpt | grep -i fw
>>
>> should show the firmware version.
>>
>>
>>> Am 23/11/2021 um 14:14 schrieb Uwe Sauter:
>>>> Am 23.11.21 um 14:04 schrieb Ralf Storm:
>>>>> Hello,
>>>>>
>>>>> I´m currently upgrading my 7-node Cluster, 1 node without problems, 2 nodes had renamed NICs to be
>>>>> corrected,
>>>>>
>>>>> but the last Node stucks at boot with this message: "mpt2sas_cm0: overiding NVDATA EEDPTagMode
>>>>> setting"
>>>>>
>>>>> Anybody had this error before?
>>>> Yes, unrelated to Proxmox. But the SAS controller works fine even with this message.
>>>>
>>>> Do you have issues accessing your storage?
>>>>
>>>>> Best regards
>>>>>
>>>> _______________________________________________
>>>> pve-user mailing list
>>>> pve-user@lists.proxmox.com
>>>> https://lists.proxmox.com/cgi-bin/mailman/listinfo/pve-user
> _______________________________________________
> pve-user mailing list
> pve-user@lists.proxmox.com
> https://lists.proxmox.com/cgi-bin/mailman/listinfo/pve-user