From: Stefan Hanreich <s.hanreich@proxmox.com>
To: pve-devel@lists.proxmox.com
Subject: Re: [PATCH networking v2] fix #6255: SNAT: fix incorrect IP collection for sdn config
Date: Mon, 22 Jun 2026 14:53:50 +0200 [thread overview]
Message-ID: <87cf364d-2253-4d47-b6f0-29120f12fceb@proxmox.com> (raw)
In-Reply-To: <20260327153959.87687-1-l.sichert@proxmox.com>
functionality-wise looks fine, some annotations to the code inline
On 3/27/26 4:39 PM, Lukas Sichert wrote:
> On a host with a SimpleZone or EVPN and SNAT configured, when changing
> the ip address of the bridge that handles the SNAT, the changes are not
> reflected in /etc/network/interfaces.d/sdn. This happens because the ip
> address is resolved via 'ip route get 8.8.8.8'. By the time this command
> is executed, no ifreload has been executed yet, so ip route still
> contains the old ip address.
>
> Determine the IP version (IPv4 or IPv6) of the address used with 'ip
> route'. Then parse the incoming /etc/network/interfaces file and look up
> the interface currently used by 'ip route'. If the interface is still
> present and has a gateway and ip address with the correct version, but
> the ip address has changed, update the ip address in the SDN
> configuration accordingly and log the change to the journal.
>
> Signed-off-by: Lukas Sichert <l.sichert@proxmox.com>
> ---
>
> Notes:
> changes from v1 to v2: (thanks @Gabriel, @Stefan)
> -add handling for IPV6 addresses
> -remove warnings for missing ip/gateway, as they might trigger
> in some legitimate scenarios
> -add canonical formatting for IPv4 and IPV6
> -execute make tidy
> -small restructuring of if clauses for earlier exit
> -fix typos
>
> concerning the ignoring of live routing tables:
>
> The function only determines the currently used interface (via 'ip
> route') and its ip address and returns these two. The gateway configured
> in /etc/network/interfaces is only used to verify that the interface is
> still a valid candidate after an 'ifreload -a'. As it cannot switch
> interfaces relative what to 'ip route' reports it should not be able
> influence gateway selection.
>
> If I am missing a more obscure way or an edge case where gateway
> selection could still be affected, please let me know.
>
> Also I have thought about adding "... does not match with its actual ip
> address reported by ip route ...", but after this would be displayed
> 'ifreload -a' gets executed and 'ip route' changes.
>
> src/PVE/Network/SDN/Zones/EvpnPlugin.pm | 5 ++--
> src/PVE/Network/SDN/Zones/Plugin.pm | 30 +++++++++++++++++++++--
> src/PVE/Network/SDN/Zones/SimplePlugin.pm | 5 ++--
> 3 files changed, 34 insertions(+), 6 deletions(-)
>
> diff --git a/src/PVE/Network/SDN/Zones/EvpnPlugin.pm b/src/PVE/Network/SDN/Zones/EvpnPlugin.pm
> index 8e7ddfd..91b8a7e 100644
> --- a/src/PVE/Network/SDN/Zones/EvpnPlugin.pm
> +++ b/src/PVE/Network/SDN/Zones/EvpnPlugin.pm
> @@ -252,8 +252,9 @@ sub generate_sdn_config {
> if ($subnet->{snat}) {
>
> #find outgoing interface
> - my ($outip, $outiface) =
> - PVE::Network::SDN::Zones::Plugin::get_local_route_ip($checkrouteip);
> + my ($outip, $outiface) = PVE::Network::SDN::Zones::Plugin::get_local_route_ip(
> + $checkrouteip, $interfaces_config,
> + );
> if ($outip && $outiface && $is_evpn_gateway) {
> #use snat, faster than masquerade
> push @iface_config,
> diff --git a/src/PVE/Network/SDN/Zones/Plugin.pm b/src/PVE/Network/SDN/Zones/Plugin.pm
> index 826ebdf..1d18acc 100644
> --- a/src/PVE/Network/SDN/Zones/Plugin.pm
> +++ b/src/PVE/Network/SDN/Zones/Plugin.pm
> @@ -8,6 +8,7 @@ use PVE::IPRoute2;
> use PVE::JSONSchema;
> use PVE::Cluster;
> use PVE::Network;
> +use PVE::SafeSyslog;
>
> use PVE::JSONSchema qw(get_standard_option);
> use base qw(PVE::SectionConfig);
> @@ -279,7 +280,7 @@ sub del_bridge_fdb {
> #helper
>
> sub get_local_route_ip {
> - my ($targetip) = @_;
> + my ($targetip, $interfaces_config) = @_;
>
> my $ip = undef;
> my $interface = undef;
> @@ -296,6 +297,31 @@ sub get_local_route_ip {
>
> },
> );
> + my $ipversion = Net::IP::ip_is_ipv6($targetip) ? 6 : 4;
> + my $interface_in_config = $interfaces_config->{ifaces}->{$interface};
> + my $ip_address_in_config = undef;
> + my $gateway_in_config = undef;
> +
> + if ($ipversion == 6) {
> + $ip_address_in_config = PVE::Network::canonical_ip($interface_in_config->{address6});
> + $gateway_in_config = PVE::Network::canonical_ip($interface_in_config->{gateway6});
> + } else {
> + $ip_address_in_config = PVE::Network::canonical_ip($interface_in_config->{address});
> + $gateway_in_config = PVE::Network::canonical_ip($interface_in_config->{gateway});
> + }
nit: potentially the following is a bit nicer?
my $address_key = ($ipversion == 6) ? 'address6' : 'address';
my $ip_address_in_config =
PVE::Network::canonical_ip($interface_in_config->{$address_key});
> + # if the device currently used for routing still has a valid description in /network/interfaces/, use it
> + if ($interface_in_config && $gateway_in_config) {
> + if ($ip_address_in_config eq $ip) {
> + return ($ip_address_in_config, $interface);
> + } else {
> + syslog(
> + "warning",
> + "ip address $ip_address_in_config of interface $interface in /etc/network/interfaces does not match with its ip address reported by ip route: $ip, switching to $ip_address_in_config for SNAT",
> + );
> + return ($ip_address_in_config, $interface);
> + }
> + }
> return ($ip, $interface);
nit: could be shortened
if (
$interface_in_config
&& $gateway_in_config
&& $ip_address_in_config ne $ip
) {
syslog(..)
return ($ip_address_in_config, $interface);
}
return ($ip, $interface);
> }
>
> @@ -323,7 +349,7 @@ sub find_local_ip_interface_peers {
>
> #if peer is remote, find source with ip route
> foreach my $address (@{$peers}) {
> - my ($ip, $interface) = get_local_route_ip($address);
> + my ($ip, $interface) = get_local_route_ip($address, $network_config);
> return ($ip, $interface);
> }
> }
> diff --git a/src/PVE/Network/SDN/Zones/SimplePlugin.pm b/src/PVE/Network/SDN/Zones/SimplePlugin.pm
> index f5cd18e..ac772e7 100644
> --- a/src/PVE/Network/SDN/Zones/SimplePlugin.pm
> +++ b/src/PVE/Network/SDN/Zones/SimplePlugin.pm
> @@ -112,8 +112,9 @@ sub generate_sdn_config {
> push @iface_config, "up ip route add $cidr dev $vnetid" if $mask == 32 && $ipversion == 4;
> if ($subnet->{snat}) {
> #find outgoing interface
> - my ($outip, $outiface) =
> - PVE::Network::SDN::Zones::Plugin::get_local_route_ip($checkrouteip);
> + my ($outip, $outiface) = PVE::Network::SDN::Zones::Plugin::get_local_route_ip(
> + $checkrouteip, $interfaces_config,
> + );
> if ($outip && $outiface) {
> #use snat, faster than masquerade
> push @iface_config,
prev parent reply other threads:[~2026-06-22 12:54 UTC|newest]
Thread overview: 2+ messages / expand[flat|nested] mbox.gz Atom feed top
2026-03-27 15:39 [PATCH networking v2] fix #6255: SNAT: fix incorrect IP collection for sdn config Lukas Sichert
2026-06-22 12:53 ` Stefan Hanreich [this message]
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=87cf364d-2253-4d47-b6f0-29120f12fceb@proxmox.com \
--to=s.hanreich@proxmox.com \
--cc=pve-devel@lists.proxmox.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.