From: Stefan Hanreich <s.hanreich@proxmox.com>
To: pve-devel@lists.proxmox.com
Subject: Re: [PATCH network v3] fix #6255: snat: update changed bridge IPs in SDN config
Date: Thu, 25 Jun 2026 18:10:19 +0200 [thread overview]
Message-ID: <3ef74118-51a9-4ea3-bb6f-b8c93be35aa6@proxmox.com> (raw)
In-Reply-To: <20260625122420.51674-1-l.sichert@proxmox.com>
gave this another quick spin with an IPv{4,6} simple vnet, lgtm:
Tested-by: Stefan Hanreich <s.hanreich@proxmox.com>
Reviewed-by: Stefan Hanreich <s.hanreich@proxmox.com>
On 6/25/26 2:25 PM, Lukas Sichert wrote:
> When changing the IP address of an SNAT bridge in a Simple or EVPN zone,
> the generated SDN configuration retains the old address. The address is
> currently obtained through 'ip route get', which still reports the
> previous state before 'ifreload' runs.
>
> Parse the incoming '/etc/network/interfaces' and look up the interface
> used by 'ip route'. If it still has a gateway and a changed IP address,
> update the SNAT address in the generated SDN configuration and log the
> change to the journal.
>
> Signed-off-by: Lukas Sichert <l.sichert@proxmox.com>
> Link: https://bugzilla.proxmox.com/show_bug.cgi?id=6255
> ---
>
> Notes:
> changes from v2 to v3: (thanks @Stefan):
> - simplified the address lookup by selecting the address and gateway key
> based on the IP version
> - add address and gateway check before canonicalzing as canonical_ip
> creates default ip from undef input
> - simplified the fallback logic for changed SNAT bridge addresses
>
> changes from v1 to v2: (thanks @Gabriel, @Stefan)
> - add handling for IPV6 addresses
> - remove warnings for missing ip/gateway, as they might trigger
> in some legitimate scenarios
> - add canonical formatting for IPv4 and IPV6
> - execute make tidy
> - small restructuring of if clauses for earlier exit
> - fix typos
>
> src/PVE/Network/SDN/Zones/EvpnPlugin.pm | 5 ++--
> src/PVE/Network/SDN/Zones/Plugin.pm | 32 +++++++++++++++++++++--
> src/PVE/Network/SDN/Zones/SimplePlugin.pm | 5 ++--
> 3 files changed, 36 insertions(+), 6 deletions(-)
>
> diff --git a/src/PVE/Network/SDN/Zones/EvpnPlugin.pm b/src/PVE/Network/SDN/Zones/EvpnPlugin.pm
> index dfbd7e9..37bc9f5 100644
> --- a/src/PVE/Network/SDN/Zones/EvpnPlugin.pm
> +++ b/src/PVE/Network/SDN/Zones/EvpnPlugin.pm
> @@ -269,8 +269,9 @@ sub generate_sdn_config {
> if ($subnet->{snat}) {
>
> #find outgoing interface
> - my ($outip, $outiface) =
> - PVE::Network::SDN::Zones::Plugin::get_local_route_ip($checkrouteip);
> + my ($outip, $outiface) = PVE::Network::SDN::Zones::Plugin::get_local_route_ip(
> + $checkrouteip, $interfaces_config,
> + );
> if ($outip && $outiface && $is_evpn_gateway) {
> #use snat, faster than masquerade
> push @iface_config,
> diff --git a/src/PVE/Network/SDN/Zones/Plugin.pm b/src/PVE/Network/SDN/Zones/Plugin.pm
> index 74a3384..5493ec1 100644
> --- a/src/PVE/Network/SDN/Zones/Plugin.pm
> +++ b/src/PVE/Network/SDN/Zones/Plugin.pm
> @@ -9,6 +9,7 @@ use PVE::IPRoute2;
> use PVE::JSONSchema;
> use PVE::Cluster;
> use PVE::Network;
> +use PVE::SafeSyslog;
>
> use PVE::JSONSchema qw(get_standard_option);
> use base qw(PVE::SectionConfig);
> @@ -306,7 +307,7 @@ sub get_iface_addresses {
> }
>
> sub get_local_route_ip {
> - my ($targetip) = @_;
> + my ($targetip, $interfaces_config) = @_;
>
> my $ip = undef;
> my $interface = undef;
> @@ -323,6 +324,33 @@ sub get_local_route_ip {
>
> },
> );
> + my $ipversion = Net::IP::ip_is_ipv6($targetip) ? 6 : 4;
> + my $interface_in_config = $interfaces_config->{ifaces}->{$interface};
> +
> + my $address_key = ($ipversion == 6) ? 'address6' : 'address';
> + my $gateway_key = ($ipversion == 6) ? 'gateway6' : 'gateway';
> +
> + # check if ip address and gateway exist in config before normalizing, because
> + # canonical_ip will return 0.0.0.0, if called with undef
> + my $ip_address_in_config;
> + if ($ip_address_in_config = $interface_in_config->{$address_key}) {
> + $ip_address_in_config = PVE::Network::canonical_ip($ip_address_in_config);
> + }
> +
> + my $gateway_in_config;
> + if ($gateway_in_config = $interface_in_config->{$gateway_key}) {
> + $gateway_in_config = PVE::Network::canonical_ip($gateway_in_config);
> + }
> +
> + # if the device currently used for routing still has a valid description in /network/interfaces/, use it
> + if ($interface_in_config && $gateway_in_config && $ip_address_in_config ne $ip) {
> + syslog(
> + "warning",
> + "ip address $ip_address_in_config of interface $interface in /etc/network/interfaces does not match with its ip address reported by ip route: $ip, switching to $ip_address_in_config for SNAT",
> + );
> + return ($ip_address_in_config, $interface);
> + }
> +
> return ($ip, $interface);
> }
>
> @@ -368,7 +396,7 @@ sub find_local_ip_interface_peers {
>
> #if peer is remote, find source with ip route
> foreach my $address (@{$peers}) {
> - my ($ip, $interface) = get_local_route_ip($address);
> + my ($ip, $interface) = get_local_route_ip($address, $network_config);
> return ($ip, $interface);
> }
> }
> diff --git a/src/PVE/Network/SDN/Zones/SimplePlugin.pm b/src/PVE/Network/SDN/Zones/SimplePlugin.pm
> index f5cd18e..ac772e7 100644
> --- a/src/PVE/Network/SDN/Zones/SimplePlugin.pm
> +++ b/src/PVE/Network/SDN/Zones/SimplePlugin.pm
> @@ -112,8 +112,9 @@ sub generate_sdn_config {
> push @iface_config, "up ip route add $cidr dev $vnetid" if $mask == 32 && $ipversion == 4;
> if ($subnet->{snat}) {
> #find outgoing interface
> - my ($outip, $outiface) =
> - PVE::Network::SDN::Zones::Plugin::get_local_route_ip($checkrouteip);
> + my ($outip, $outiface) = PVE::Network::SDN::Zones::Plugin::get_local_route_ip(
> + $checkrouteip, $interfaces_config,
> + );
> if ($outip && $outiface) {
> #use snat, faster than masquerade
> push @iface_config,
prev parent reply other threads:[~2026-06-25 16:10 UTC|newest]
Thread overview: 2+ messages / expand[flat|nested] mbox.gz Atom feed top
2026-06-25 12:24 [PATCH network v3] fix #6255: snat: update changed bridge IPs in SDN config Lukas Sichert
2026-06-25 16:10 ` Stefan Hanreich [this message]
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=3ef74118-51a9-4ea3-bb6f-b8c93be35aa6@proxmox.com \
--to=s.hanreich@proxmox.com \
--cc=pve-devel@lists.proxmox.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.